After 486Tang, I wanted to go back to where x86 started. The result is z8086: a 8086/8088 core that runs the original Intel microcode. Instead of hand‑coding hundreds of instructions, the core loads the recovered 512x21 ROM and recreates the micro‑architecture the ROM expects.

z8086 is compact and FPGA‑friendly: it runs on a single clock domain, avoids vendor-specific primitives, and offers a simple external bus interface. Version 0.1 is about 2000 lines of SystemVerilog, and on a Gowin GW5A device, it uses around 2500 LUTs with a maximum clock speed of 60 MHz. The core passes all ISA test vectors, boots small programs, and can directly control peripherals like an SPI display. While it doesn’t boot DOS yet, it’s getting close.

Since releasing 486Tang, I’ve been working on recreating the 8086 with a design that stays as faithful as possible to the original chip. That exploration naturally led me deep into the original 8086 microcode — extracted and disassembled by Andrew Jenner in 2020.

Like all microcoded CPUs, the 8086 hides a lot of subtle behavior below the assembly layer. While studying it I kept extensive notes, and those eventually evolved into something more useful: an interactive browser for the entire 8086 microcode ROM.